I’ve been using gyroid infil almost exclusively since I first tried it.

I was using cubic before, which was fine, but gyroid seems much sturdier for the same % infil even if it does take a bit more print time.

Also it looks awesome.

  • Jtskywalker@lemm.eeOPEnglish
    3·
    1 year ago

    That’s a cool idea for the coaster! I might do that if I ever get into pouring resin

    • 4lan@lemmy.worldEnglish
      3·
      1 year ago

      Thanks! It’s fun to mix both skills into one project.

      Here is how they turned out

          • Jtskywalker@lemm.eeOPEnglish
            1·
            1 year ago

            I thought so but I’ve only ever used it on taller TPU prints where I want them to basically be hollow so I’ve never seen it look quite like that!

            • 4lan@lemmy.worldEnglish
              2·
              1 year ago

              fairly high infil percentage if I remember correctly. I did 20% first and it was very sparse