I’ve been tuning to print at a 0.1mm layer height, the ironing turned out like this. The left side of the Z is a little textured and more shiny.

Why did this happen and how could I fix it?

  • jeansburger@lemmy.world
    link
    fedilink
    English
    arrow-up
    6
    arrow-down
    2
    ·
    1 year ago

    It’s because your nozzle is ever so slightly too low when you’re printing. I’d adjust your Z offset by one click upwards.

    Reprint the cube, and see if that resolved it. If not adjust upwards by another click.

    If after a handful of times you can’t get a decent ironing pass, I’d take a look at your extrusion multiplier. Drop it down by 0.01 and recalibrate and retry doing the above ironing calibration sequence again.

  • rambos@lemm.ee
    link
    fedilink
    English
    arrow-up
    4
    ·
    1 year ago

    Try monotonic order on top player. I never tried it with ironing, but its worth a shot

    • moody@lemmings.world
      link
      fedilink
      English
      arrow-up
      11
      ·
      1 year ago

      Ironing is a 3d printing term where the heated nozzle is used to smooth the final layer, it’s not about taking an actual iron to your print.

      The print shown is a calibration cube, meant to show you the results of your print settings so you can adjust them to get better prints.