I have been printing a number of sculptures this week and while mostly good, I am seeing repeated issues associated with settings.
First, supports will wrap around a hand or foot and can be difficult or impossible to remove without damaging the print.
Second, a support will fall over resulting in spaghetti infill/gaps for a portion of the print.
I am printing with both a Bambu Lab P1P and X1C using Overture Rock White PETG.
Your prints look amazing honestly. Dont expect injection moulding quality. It can be improved a bit with bigger gap or different supports, but models like this are quite difficult to print on FDM. Postprocessing is kinda normal