I am about to take delivery of a new monitor, a Dell Ultrasharp U2724D, and I have a question about the audio…

I know this sounds confusing, but hear me out…

I built my computer a few years ago, sadly the audio broke a few days later, I first the rear output stopped working, then I used the front output and a few days later the cable I used caught my chairs armrest and my computer fell on it’s side, during this the headphone jack broke.

I currently use the headphone out on my Philips monitor and run it to a generic noname analog amplifier to my Roth Audio OLi RA-1 speakers, this works fine, but there is an issue with the new monitor.

It does not have a headphone out, but a line out.

Would you expect a generic amp to work with that?

I bout the amp seven/eight years ago at the Swedish chain store Kjell & Company, it is labelled “Roxcore A32” and has two RCA inputs at the back.

I have no idea about this.

  • max@lemmy.fishEnglish
    2·
    27 days ago

    If you’re feeling adventurous, you could cut your front panel audio wires and connect them to a new 3.5mm jack inside the case. It might be a lil janky but it would get the job done for <$10

    AudioQuest Dragonfly wouldn’t be a bad way to go. I have a Red on my PC because the onboard mobo audio picks up USB noise. I’ve also got a Cobalt for my phone/headphones. They have a firmware update utility for the Red/Black that you manually install and can uninstall afterwards, the Cobalt ships with current FW and hasn’t been updated yet. That said, they’re pretty expensive for what they are and I got both of mine 50+% off. If you’re considering a “proper” audio setup, I’d go straight to to the Denon unit you’re looking at