Has anyone thought about printing narrower lines in order to get sharper corners? Once Linear advance or Pressure advance is activated, you don’t get bulging corners anymore… but can we do better?

Has this been implemented anywhere yet? Does it have a name?

  • callcc@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    3
    ·
    11 months ago

    Hmm, not exactly sure I get your argument. I imagine every extrusion to tip slightly to the outside of the curve since material is elongated on the outside and squeezed on the inside. The excess material would be pushed to the inside while the outside of the curve would sink. Is that what you mean?

    • sj_zero@lotide.fbxl.net
      link
      fedilink
      arrow-up
      2
      arrow-down
      1
      ·
      11 months ago

      in 3d space, your corner extrusion would suddenly be much thinner, so the choices for your filament would be to either droop to be supported by the previous layer or for the filament to sit underextruded in space if your part cooler is really up to the challenge.

        • sj_zero@lotide.fbxl.net
          link
          fedilink
          arrow-up
          1
          ·
          11 months ago

          Because that’s what happens when you reduce the amount of material being extruded in order to create much thinner lines in order to create sharper corners.

          • Honytawk@lemmy.zip
            link
            fedilink
            English
            arrow-up
            2
            ·
            11 months ago

            But the corners will have the same amount of material, since it is basically extruding 2 times on the same location during a corner.

            Which is why the original corners have too much material.

            • callcc@lemmy.worldOP
              link
              fedilink
              English
              arrow-up
              2
              ·
              11 months ago

              At this point there is basically only one way of knowing :D. I’ll generate some g-code and give it a go.

          • callcc@lemmy.worldOP
            link
            fedilink
            English
            arrow-up
            1
            ·
            11 months ago

            It’s all a question of what exactly “much thinner” means, I expect to have some positive effect of the proposed method even when the minimum extrusion width is above the threshold where things become too thin.

            Overall I expect the described method to make more sense with large nozzles and wide extrusions.

            Thanks for explaining what you mean!