Just finished installing it this evening. Going to update the firmware, run thermal model, and PID tune tomorrow. Also installed the silicone bed mod and need to level everything out. Got a busy day tomorrow, wish me luck.

  • 🖖USS-Ethernet@startrek.websiteOPEnglish
    3·
    11 months ago

    They make hotends with quick swap nozzles? This picture is of the E3D Revo hotend replacing the stock E3D v6 in the Prusa MK3S+.

    • 4lan@lemmy.worldEnglish
      2·
      11 months ago

      that’s a decent reason if you switch nozzles often. I leave a 0.6mm on my K1 Max permanently, best of both worlds

      • 🖖USS-Ethernet@startrek.websiteOPEnglish
        1·
        11 months ago

        I had a .25 nozzle for small details but swapping is a pain in the ass with having to heat up to unscrew it. Then my heater block moves with it. Then you have to hope you don’t drop the hot nozzle on your bed and dent it (I know). I tend to print a variety of things so being able to quick swap will be nice.

        • yokonzo@lemmy.worldEnglish
          1·
          11 months ago

          Or if you don’t screw it in JUST RIGHT It decides to become thinner than water and shoot out the sides 🥹

            • yokonzo@lemmy.worldEnglish
              2·
              11 months ago

              Its something really dumb like forgetting to heat up your hotend before you install it and it doesn’t make a seal or something