I’m looking to buy an intermediate level printer to upgrade from a MK2, and I’m deciding between a P1S vs a MK4.

I have never considered getting anything other than a Prusa, since I’ve had such good experiences using mine, however I heard that recently they’ve switched away from their open source model(?)

That and being made in the EU was the main differentiating factor for me, however I do hear really good things about Bambu printers.

Does anyone have experience with either?

Edit: Found a lot of the information I was looking for here: https://lemmy.world/post/9500502

  • Aux@lemmy.worldEnglish
    1210·
    11 months ago

    The biggest difference between the two is CoreXY vs CoreXZ. CoreXZ printers like Prusa MK4 are useless in my opinion. Constant bed side to side movement causes your model to vibrate and this vibration amplitude increases with every layer. That means you either have to print everything very slowly or limit yourself to very short models. You’re also missing out on cooling performance.

    If you’re looking for an actual upgrade, I’d recommend looking away from bed slingers. Please note that I’m not saying that you should buy any Bambu products, just don’t buy bed slingers.