• tinyVoltron@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      8 months ago

      I got the 5 a few years back. Great printer but I didn’t like the bounce in the platform so I printed stabilizers. Didn’t like the placement of the extruder moved it up top. Added the HeroMe. Still didn’t like the bounce of the plate so added a second z-axis. Added direct drive extruder. Linear rails. SKR mini. AC bed heater. Klipper. Mosquito Magnum. Prolly some other stuff. About the only original parts are the frame. I used it to learn how to print. And I printed some great stuff along the way. But it’s good now. I pretty much just print. But I really like that Bondtech LGX. Might have to try that out. :-D

    • Bocky@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      8 months ago

      Mine does too now. But I got a bad batch of pla and I could have sworn the sender was the shittiest printer on the market. It was off line for a year before I tried again. I recently switched back to that old roll because I wanted the color, and that shit peeled up and warped to hell again. Now I know for sure that spool of PLA is bad

    • NightAuthor@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      8 months ago

      I think I just about dialed in a profile, but I’ve yet to get to a place where I can just hit print and get a thing. Tinkering with it was fun for a minute, but i want a system that just works. And if that means buying a prusa printer, with prusa slicer, and prusament I’d be more than happy to go that route. I want to focus on what to print, not how. At least not now, I could definitely see me getting into it more, and then wanting to eventually do more complicated stuff requiring customizations of hardware and software, and materials, but it’s hard to get in the mood to go deep when struggling to do the basics.

    • HewlettHackard@lemmy.ca
      link
      fedilink
      English
      arrow-up
      1
      ·
      8 months ago

      Lower cost products sometimes have more variability and maybe you got a good one from the factory.