My prints come out very well but I’m noticing on larger prints that one corner of my bed prints tighter than the opposite. What’s causing this?

Printing on an Ender 3 Pro with upgraded metal extruder, beefier bed springs and metal levelers, and upgraded hot end. Not direct drive yet and no auto bed leveling.

  • rambos@lemm.eeEnglish
    0·
    8 months ago

    Your whole model needs more squish, but that corner a bit more than the rest. There shouldnt be gaps visible between lines

      • rambos@lemm.eeEnglish
        1·
        8 months ago

        When I say more squish, I mean get your nozzle closer to the print bed or increase extrusion rate. Gaps between print lines are visible and they shouldnt be.

        Sorry if I was unclear, I was even surprised I got downvote LOL