This is a custom wall mount for my 2nd screen Dell P2417H (simmilar models with same stand will fit as well). It’s a 24" monitor with pivot stand (can adjust up/down, portrait/landscape and tilt), but it doesnt suppport vesa mount (edit: this is wrong, it does support vesa, but then cant use pivot mechanism). I wanted it on the wall so I printed 3 parts out out of PLA. One part is screwed in the wall and the other one is securing monitor in place using zip ties. 3rd part is a small shelf that is mounted underneath (with original screw for monitor base), but its there mostly to provide a flat surface between monitor and a wall.

I’ve been using it (2 actually) for few years in old place and I love it. It can be a bit tricky to tighten zip ties, but its only done once anyway.

I’ll upload files if someone needs them

  • WoodenDing@lemm.ee
    link
    fedilink
    English
    arrow-up
    12
    ·
    7 months ago

    This just goes to show that people with a 3d printer would rather design their own solution rather than taking 10 seconds to figure out an already existing one.

    • rambos@lemm.eeOP
      link
      fedilink
      English
      arrow-up
      4
      arrow-down
      1
      ·
      7 months ago

      Haha I agree Im like that! But IMO, In this case it really made sense to design and print a custom mount to keep existing pivot mechanism, at least for me