So someday ago I tried to fit in the “Back Mounted Electronic Box By Teaching Tech” On my Ender3 (OG). Only problems… 1st: The box would not fit (The tolerances on my printer are awful) so I spent 2hrs sanding down the box. 2nd: The printer would not turn on, it took me a day to realize that I wired the cooling fan BACKWARDS.

My objective in this Project is to gain Cable Management on my printer (Which is now far worse than before btw, will try to fix) and I am running Klipper on a [RASPBERRY PI 3B+] (do you see where I am going?)

So I try to reduce the amount of unnecessary cables AND I WAS WONDERING (Since I saw the fact on a Teaching Tech video) if I could connect the raspberry pi power directly From the motherboard (SKR MINI E3 V2.0) to the PI’s gpio to power it.

So my question is:

On what ports should I connect the two (+5V and GND) cables ON THE MOTHERBOARD and THE PI’S GPIO.

If you did not understand something feel free to ask me.

Video link: https://youtu.be/yW9ovo9CHi0?t=320

  • thews@lemmy.world
    link
    fedilink
    arrow-up
    1
    ·
    1 year ago

    If you google “skr mini e3 v2 pinout” you can find 5v and ground pins. The question is how much load is already on it’s 5v regulator and how much are you adding.

    You can power the pi from a buck converter or from whatever else.

    They apparently make an addon 5v buck converter for that board.

    Using a multimeter could help avoid frying more stuff.