Hello Lathe Ladies, Mitre Mates, and Plywood Pals!

I’ve been tracking my kids’ heights on a wall for several years but I’d like a prettier solution. Something I can screw on the wall and mark their heights on (maybe temporarily and then go back with a wood burner or something). Ideally, sometime that’s two identical adjacent pieces that I can give them if I’m ever lucky enough to be a grandparent.

A straight 7’ board with a cutout for the moulding and burnt or painted 6" increments is the simplest solution, but can y’all think of anything nicer? I would prefer to keep it on a semi visible wall instead of the laundry closet.

Thanks friends.

  • DavidP@midwest.social
    5·
    4 months ago

    This is what I did for you our kids. Used a bull nose but in a router for the engraving. The graduations were done with a straightedge while the numbers were freehanded over pencil lines.

    I then spray painted it black and sanded off the paint from the flat surfaces, leaving it paint in the engraving troughs.

    Their heights are simply penciled on.

    We’re pretty pleased with it. It looks nice and doesn’t feel out of place.