Should go after anywhere that has perpetual agreements including the ones that try to get around it by the last living clause or 100 years etc. I don’t know a good solution but I’m sure they can put limits and carve outs where needed.

Hmm kinda like what they did before. It worked. I knew I was going to get one and the community built a spreadsheet tracking estimates dates.

No because it’s not decentralized. That’s like saying Twitter is decentralized because it’s microservices communicate over https.

That overlay has such bad contrast it’s hard to see what’s going on. Big accessibility issue.

Really same reason all these companies making dramatic changes. Rips the bandaid off and lets them roll back to what they actually wanted while looking like they listen. Some are executed better than others. See Deltas medallion change for another example.

It’d be fun to mess around with if it wasn’t 12-18k for the setup.

More surprised you managed to post a negative review. Every time I do it fails amazons community guidelines check or get removed a few days after.

It’s a bit overblown IMO. Unless you’re going wild with multi material it’s about the same as any other printer. Sure it purges a little even if you don’t change filament between prints but it’s still such a small amount. I found myself purging a little each time with my Prusa and Enders before too.

If you’re that worried don’t get an ams for multi color printing. Get an ams to reduce waste for automatic spool runout switching.

No body was asking for it either. Now they have a reason to raise prices. And they will.

I’d argue you’re not really losing it if you never use it all in the first place. People put too much thought into range when all they’re doing is short trips most of the time.

It’s weird calling for one mega corp to be split up while supporting another mega corp that owns more than the first. Everyone needs a reality check if they think any mega corp doesn’t want the same thing.

Those kind of dryers don’t really let the moisture escape, it needs somewhere to go. Either with desiccant + fan or ideally food dehydrator.

Shoulda bought when it was a broken mess. Bestbuy was clearing out the console editions.

They’re not free.

And it’s weird, this kinda tech isn’t new at all.

Are you sure it’s not a you doing something shady problem? Suspended on printables, locked on thangs… I dunno it sounds kinda sus when none of us have issues. Perhaps it’s spamming your cube…

It’s been a thing for a while but they might be adding more sites to their index.

I do like the idea of thangs, it just needs more time to mature and they need to limit their search - mainly not including game asset and mod sites.

Lol thangs search better? Please. The entire thangs UX is a mess and their search is a joke. It returns models from game asset websites and the like that are not really printable. They’ve been spending a lot getting creators to gush over it too, makes me highly suspect whenever I see someone say how much better it is.

You can use your heated bed, just set a temp and cover the roll with a box.

https://3dprinterly.com/how-to-dry-filament-like-a-pro-pla-abs-petg-nylon-tpu/ Scroll down to the heated bed portion