minus-squaredignin@lemmy.worldto3DPrinting@lemmy.world•Unable to print PLAlinkfedilinkEnglisharrow-up2·1 year agoThe Ptfe tube is likely the answer, if you can replace I recommend trying to. Make sure it is seated correctly and properly clamped in place when you’re putting it back together. Good luck! linkfedilink
minus-squaredignin@lemmy.worldtoTechnology@lemmy.world•Reddit is a Dying MalllinkfedilinkEnglisharrow-up4arrow-down1·1 year agoMaybe an AI wrote it. 🥸 linkfedilink
The Ptfe tube is likely the answer, if you can replace I recommend trying to. Make sure it is seated correctly and properly clamped in place when you’re putting it back together.
Good luck!