They never will because then they would need to give valve a cut for the micro transaction purchases made in the ubisoft launcher. Also they lose that advertising platform

They meant you see video evidence of it on YouTube, not go yourself.

Dishonored series was pretty good at offering and rewarding a peaceful playthtrough. It was definitely the more difficult option but usually worth it.

While I can’t say I’ve paid more for less as a whole, I’ve definitely had a higher fun to dollar with SC than many other more finished, flashier games. It’s what you make of it and the people you meet along the way, just like any other MMO. It definitely has its warts and issues, but I think a lot of people also hate it because they were told it was bad and evil and I don’t think that’s really true. It has the trappings of any large game service products which people call greedy but it does cost a lot to run. I think a lot of the criticism boils down to that’s a lot of money and not a lot of fast progress, and that’s fair but this game is also unique in being public from a far too early point of development and many other games with smaller scopes are just as slow when developing a new engine/IP (relative to the scope) but the public doesn’t see much until we get to just about this point in development.

Those don’t seal well, so probably not

Aircraft maintenance has been doing the negative pressure unlock tests on cockpit doors for decades, its honestly surprising what isn’t common knowledge. Like others have said, rapid decompression of only a portion of the aircraft is very bad, and will result in massive structural failure as individual compartments aren’t pressure rated and will blow apart. The doors I’ve had experience with had large panels that would pop out when in a negative pressure event.

Honestly, the second half of this post is not a very true statement, and is pretty disingenuous to reality. The Bambu ecosystem can operate independently of Bambu labs if you want/need to, there are plenty of knock off replacement parts to keep it running long term, you can buy all the consumables from amazon/aliexpress and many of the other components. The slicer has a feature rich open source alternative too, so software isn’t an issue. The only thing it has against it is its not open source. I own both a prusa and now 2 Bambu printers. I spent a long time researching what I was going to purchase to upgrade my prusa printers. The mk3.9 upgrade for my mk3s+ was almost the cost of a whole new printer, and new units were more expensive than the p1s. The p1p/s has more build volume, is faster, and has been more reliable and in general usable than my prusa ever was. I want to support prusa but they have fallen way behind in nearly every way. If you don’t want your data collected and you desire privacy you can have that with a closed source product, it’s not impossible. And you can get a better machine at 2/3 the cost of a prusa or a multi material one at the same cost.

I can’t speak to the all in one dream machine, though I’m sure it’s similar in capability to my UDM pro, which has been fairly solid for me and only really has had trouble when I induced it myself. It’s definitely much more complex and open than most home routers, and allows you to set every single thing you can think of, the drawback though is that it’s not as automated as some home routers and you need to know what you are setting more in depth when you step off the auto modes. Overall I’ve been very happy with my unifi setup. I also use Protect and I’m looking to set up Access too soon(ish).