This one didn’t print right but I’m gonna try it again later I might change up the color too

        • CmdrShepard@lemmy.oneEnglish
          5·
          11 months ago

          You leave a magnet sized cavity inside the print and have it set to pause right before covering that cavity up and slip your magnet inside the print.

            • JackGreenEarth@lemm.eeEnglish
              3·
              11 months ago

              Not in an accusatory way, purely out of interest, why are you on the 3d printing community if you haven’t done any 3d printing?

              I know there could be several valid reasons, I’m just interested which one it is.

              • magnetosphere@kbin.social
                4·
                11 months ago

                I was just scrolling along, and this post showed up. The pic grabbed my attention, so I read the thread.

                The built-in magnet thing has me wondering what else you could do. Maybe make a pet toy with a little bell inside? Make a ball that rolls unpredictably, because although it’s smooth outside, hidden inside is a marble rolling along an irregular surface?

                • CmdrShepard@lemmy.oneEnglish
                  5·
                  11 months ago

                  See this is funny because you have an imaginative mind yet don’t 3D print while I don’t have a very imaginative mind and do 3D print (mostly relying on other people’s designs). You might look at getting into the hobby if it’s something that interests you. Entry level machines start at $100-$200 and filament is around $20-$30 for 1KG.

                • JackGreenEarth@lemm.eeEnglish
                  1·
                  11 months ago

                  That does sound cool. You’d have to make sure the bell would be safe with molten filament on it, but yeah.

  • Kyyrypyy@lemmy.worldEnglish
    5·
    11 months ago

    I’m saddened that I could not find that “It’s a pentagram” -scene from the “Angels and demons” -movie. I hadn’t really taken note of the fediverse -logo before this.

  • Tenthrow@lemmy.worldEnglish
    3·
    11 months ago

    If you are up for suggestions. I would swap filaments at the layer after the base is finished and switch colors so that the logo will pop against the base color.

  • Pacrat173@lemmy.mlOPEnglish
    2·
    11 months ago

    Ah yea forget a important part there was a hole on the back where I was gonna put the magnet into so that’s what would make it a magnet

    • Tenthrow@lemmy.worldEnglish
      4·
      11 months ago

      When I make magnets on the printer. I create voids the shape of the magnet in the model near the bottom surface, then have the printer pause right before it the layer it is set to close the hole. Drop the magnets in and resume print. It will completely encase the magnet.

    • dual_sport_dork 🐧🗡️@lemmy.worldEnglish
      3·
      11 months ago

      I was going to say, other than that it looks pretty 'aight to me.

      You could just glue a disk magnet to the back, couldn’t you? I have oodles of various souvenir magnets that are made by just hot gluing a cheap ferrite disk to whatever piece of bric-a-brac. I think that would be acceptable.

      It’s not an un-magnet. It’s a multipurpose medallion. Bring your own magnet, lapel pin clip, or Velcro.