I love in Colorado, which is a pretty dry state, so while I had heard of “wet filament”, I never considered it to be a problem that I would have to worry about. I had seen people creating dry storage bins for their filament, but figured that must just be for people in humid climates.

When I first bought my 3D printer a few years ago, I did what most people probably do - I bought a 10 pack of different filament colors. Everything printed great for a while, but eventually, my prints just started to kind of suck. I made a few upgrades to my printer, but still couldn’t pinpoint what was going on. What was frustrating, is that some times my prints would be great - but other times I couldn’t even print the most simple prints without problems.

I eventually noticed that my great prints were from newer filament that I had recently purchased, but my bad prints were coming from spools I’ve had sitting out for a while. So I purchased a $40 filament dryer on Amazon and it instantly fixed all the problems I’d been having.

I feel dumb, because I had gone through three different extruders, new hot ends, new nozzles, tubing, and spent tons of time cleaning and tightening stuff on my printer. I had left my printer untouched for months because it was just so frustrating. Something as simple as old filament left out never occurred to me until much later.

TLDR; If your prints have started to suck after a while, you might want to try drying your filament.

  • elauso@feddit.deEnglish
    2·
    6 months ago

    I still don’t understand how those cheap filament dryers work: they fully enclose the spool and heat up the air for a few hours. But where does the moist air go? It’s still trapped in there with the filament. It makes no sense!

    I always leave the filament dryer a bit open so the warm air can escape, taking the moisture to a better place (far away from the filament)

    • scutiger@lemmy.worldEnglish
      3·
      6 months ago

      You’re supposed to put some type of desiccant like silica gel beads that will pull that moisture out of the air.

      Leaving the box open will just let humid air in. You can’t let air out without also letting air in unless you have some sort of vacuum pump.

    • jballs@sh.itjust.worksOPEnglish
      1·
      6 months ago

      Now that you mention it, I have no clue! There’s no exhaust fan on mine. It definitely works though, so I assume the people that made it are smarter than me.